Ghosh, M and Kumar, K and Kailas, SV and Raychaudhuri, AK (2010) Optimization of friction stir welding parameters for dissimilar aluminum alloys. In: Materials & Design, 31 (6). pp. 3033-3037.
materials.pdf - Published Version
Restricted to Registered users only
Download (863Kb) | Request a copy
Assembly consisting of cast and wrought aluminum alloys has wide spread application in defense and aero space industries. For the efficacious use of the transition joints, the weld should have adequate strength and formability. In the present investigation, A356 and 6061 aluminum alloys were friction stir welded under tool rotational speed of 1000-1400 rpm and traversing speed of 80-240 mm/min, keeping other parameters same. The variable process window is responsible for the change in total heat input and cooling rate during welding. Structural characterization of the bonded assemblies exhibits recovery-recrystallization in the stirring zone and breaking of coarse eutectic network of Al-Si. Dispersion of fine Si rich particles, refinement of 6061 grain size, low residual stress level and high defect density within weld nugget contribute towards the improvement in bond strength. Lower will be the tool rotational and traversing speed, more dominant will be the above phenomena. Therefore, the joint fabricated using lowest tool traversing and rotational speed, exhibits substantial improvement in bond strength (similar to 98% of that of 6061 alloy), which is also maximum with respect to others. (C) 2010 Elsevier Ltd. All rights reserved.
|Item Type:||Journal Article|
|Additional Information:||Copyright of this article belomgs to Elsevier Science.|
|Department/Centre:||Division of Mechanical Sciences > Mechanical Engineering|
|Date Deposited:||08 Jun 2010 07:17|
|Last Modified:||19 Sep 2010 05:59|
Actions (login required)