Menezes, Pradeep L and Kishore, * and Kailas, SatishV and Bobjib, MS (2010) Influence of tilt angle of plate on friction and transfer layer—A study of aluminium pin sliding against steel plate. In: Tribology International, 43 (5-6). 897 -905.
ncsi.pdf - Published Version
Restricted to Registered users only
Download (854Kb) | Request a copy
In the present investigation, unidirectional grinding marks were attained on the steel plates. Then aluminium (Al) pins were slid at 0.2°, 0.6°, 1.0°, 1.4°, 1.8°, 2.2° and 2.6° tilt angles of the plate with the grinding marks perpendicular and parallel to the sliding direction under both dry and lubricated conditions using a pin-on-plate inclined sliding tester to understand the influence of tilt angle and grinding marks direction of the plate on coefficient of friction and transfer layer formation. It was observed that the transfer layer formation and the coefficient of friction depend primarily on the grinding marks direction of the harder mating surface. Stick-slip phenomenon was observed only under lubricated conditions. For the case of pins slid perpendicular to the unidirectional grinding marks stick-slip phenomenon was observed for tilt angles exceeding 0.6°, the amplitude of which increases with increasing tilt angles. However, for the case of the pins slid parallel to the unidirectional grinding marks the stick-slip phenomena was observed for angles exceeding 2.2°, the amplitude of which also increases with increasing tilt angle. The presence of stick-slip phenomena under lubricated conditions could be attributed to the molecular deformation of the lubricant component confined between asperities.
|Item Type:||Journal Article|
|Additional Information:||copyright of this article belongs to Elsevier Science.|
|Department/Centre:||Division of Mechanical Sciences > Materials Engineering (formerly Metallurgy)
Division of Mechanical Sciences > Mechanical Engineering
|Date Deposited:||22 Apr 2010 11:42|
|Last Modified:||19 Sep 2010 06:00|
Actions (login required)