Ganguli, Ranjan and Gorb, S and Lehmann, FO and Mukherjee, S (2010) An Experimental and Numerical Study of Calliphora Wing Structure. In: Experimental Mechanics, 50 (8). pp. 1183-1197.
Experimental.pdf - Published Version
Restricted to Registered users only
Download (777Kb) | Request a copy
Experiments are performed to determine the mass and stiffness variations along the wing of the blowfly Calliphora. The results are obtained for a pairs of wings of 10 male flies and fresh wings are used. The wing is divided into nine locations along the span and seven locations along the chord based on venation patterns. The length and mass of the sections is measured and the mass per unit length is calculated. The bending stiffness measurements are taken at three locations, basal (near root), medial and distal (near tip) of the fly wing. Torsional stiffness measurements are also made and the elastic axis of the wing is approximately located. The experimental data is then used for structural modeling of the wing as a stepped cantilever beam with nine spanwise sections of varying mass per unit lengths, flexural rigidity (EI) and torsional rigidity (GJ) values. Inertial values of nine sections are found to approximately vary according to an exponentially decreasing law over the nine sections from root to tip and it is used to calculate an approximate value of Young's modulus of the wing biomaterial. Shear modulus is obtained assuming the wing biomaterial to be isotropic. Natural frequencies, both in bending and torsion, are obtained by solving the homogeneous part of the respective governing differential equations using the finite element method. The results provide a complete analysis of Calliphora wing structure and also provide guidelines for the biomimetic structural design of insect-scale flapping wings.
|Item Type:||Journal Article|
|Additional Information:||Copyright of this article belongs to Sage Publications.|
|Keywords:||Micro air vehicle; Calliphora; Mass per unit length; Flexural rigidity; Torsional rigidity; Natural frequency; Finite element method|
|Department/Centre:||Division of Mechanical Sciences > Aerospace Engineering (Formerly, Aeronautical Engineering)|
|Date Deposited:||04 Nov 2010 11:00|
|Last Modified:||04 Nov 2010 11:00|
Actions (login required)